main logo

Raspberry Pi Phone

I 10 migliori prodotti di ottobre 2024
Ultimo aggiornamento: 4 ottobre 2024
CQRobot
CQRobot
CQRobot TSL25911FN Ambient Light Sensor Compatible with Raspberry Pi, Arduino, STM32. 0 to 88000Lux Detection Range, 600M: 1 Wide, for Industry, Mobile Phone, Computer, Lighting, GPS, etc.
Spedizione gratuita
star

91

QUALITÀ DISTINTA

VEDI SU AMAZON
Amazon.it
#4

  • TSL25911FN is a very-high sensitivity light-to-digital converter that transforms light intensity into a digital signal output capable of direct I²C interface. The device combines one broadband photodiode (visible plus infrared) and one infrared-responding photodiode on a single CMOS integrated circuit.
  • Two integrating ADCs convert the photodiode currents into a digital output that represents the irradiance measured on each channel. This digital output can be input to a microprocessor where illuminance (ambient light level) in lux is derived using an empirical formula to approximate the human eye response.
  • High sensitivity up to 188uLux, wide dynamic range up to 600M:1. Embedded infrared-responding photodiode, allows precise measuring even on strong infrared noise environment.
  • Embedded ADC, direct light intensity signal output to I2C interface, less noise jamming. Provides interrupt output with programmable upper and lower thresholds.
  • CQRobot Ambient Light Sensor Built-in TSL25911FN chip, Onboard voltage translator, compatible with 3.3V/5V operating voltage, Compatible with Raspberry Pi, Arduino, STM32 and other motherboards. Adopts TSL25911FN, measures infrared plus visible light. (wider range than TSL2561)
  • 12,99 € SU AMAZON
CQRobot
CQRobot
CQRobot TCS34725FN RGB Color Sensor Compatible with Raspberry Pi/Arduino/STM32. I2C Interface, Output RGB Data/Light Intensity Table. for Light Test, Phones, Computers, Industries, Lighting.
Spedizione gratuita
star

79

QUALITÀ BUONA

VEDI SU AMAZON
Amazon.it
#7

  • TCS34725FN is a low-cost, cost-effective RGB full-color color recognition sensor. The sensor recognizes the surface color of an object through optical sensing. It supports the three primary colors of red, green, and blue (RGB), supports bright light sensing, and can output the corresponding specific values to help you restore the true colors, and includes an IR blocking filter making it an ideal color sensing solution for use under varied lighting conditions.
  • CQRobot RGB Color SensorOnboard TCS34725FN, embedded ADC, high sensitivity, wide dynamic range. I2C communication, uses a few pins. Integrates IR blocking filter, minimizes the IR spectral component of the incoming light.
  • Outputs RGB data without white balance. Outputs light intensity, feels the light like human eyes. Supports light intensity interrupt output, programmable upper and lower thresholds. Supports fill-light by onboard LED, adjustable brightness by PWM.
  • Onboard voltage level translator, compatible with 3.3V/5V operating voltage. Compatible with motherboards such as Raspberry Pi/Arduino/STM32.
  • for Medical Health, Fluid and Gas Analysis, Color Temperature Measurement, Backlight Control for RGB LED, Product Color Verification and Classification, Ambient Light Sensing for TVS, Cell Phones, Tablets, Printer, Computers and Monitors, etc.
  • 14,99 € SU AMAZON